High Voltage Parallel Programmer AVR

1 Comment »

AVR has two different programming modes called Parallel Programming Mode (Parallel Mode) and Serial Downloading Mode (ISP mode).

At the Parallel Mode, the device to be programmed is put on the programmer’s socket and +12 volts programming voltage is required to its RESET pin. Communicating between the programmer and the device is done in parallel programming commands, so that the programing speed is two times faster than ISP mode. This programming mode is used to pre-program many devices or/and ISP mode cannot use due to the board design. However, most programmers except STK500 seem not to support this programming mode. Using High voltage parallel programmer can recovery wrong fuse bit setting.

Schematics Download :

  1. Circuit Diagram for Parallel/HVS Programmer
  2. Socket Converters for Parallel Programmer
  3. Circuit Diagram for 8/14pin HVS Programmer

Software Download :

  1. AVRPP.EXE(Win32) & Source

[Link]

Incoming search terms for the article:

General purpose infrared remote control receiver with RS232 output

1 Comment »

I have done a simple infrared remote control receiver with RS232 ascii output. It can be used for developing remote controls on a PC using the serial port. In practice, the infrared bursts are converted in ascii characters and sent to the RS232 port. The downloadable ZIP file contains the schematic diagram, the printed circuit board, the components disposition and the object file to write into the ATMEL ATtiny2313 microcontroller.

Link [Via]

Keypad Using Parallel Port

2 Comments »

** This Schematic need driver , Please Send Email to admin@makecircuits.com for driver