USBtoparallel

USBtoparallel

This device was built using AVRUSB firmware developed by extern Objective Development.

Meanwhile, a very similar Release 1.6 exists.

This Low-Speed device violates following USB specification rules:

* Detachable cable (must be captive for Low-Speed)
* Output drivers with 5 V (must be 3.3 V, but USB is 5 V tolerant)
* No differential data input (only one line D- is sampled)
* No data clock regenration while receiving (only at packet start)
* No error detection of input data (OUT direction), no time for CRC16
* Data transfer using BULK pipes (not specified for low-speed, but works on Windows – for Linux there is an “Alternate Setting” with INTERRUPT pipes instead)

However, new to this firmware, following rules are accepted:

* Suspend detection and lowered suspend current (below 500 µA)

[Via]

Incoming search terms for the article:

Related posts:

  1. USB to RS232 Using Atmel ATtiny2313 or ATmega8 The Universal Serial Bus (USB) interface has become extremely...
  2. High Voltage Parallel Programmer AVR AVR has two different programming modes called Parallel Programming...
  3. Simplest atmega8 programmer Using LPT Port * R1-R4 = 220R Atmega 128 is like other...
  4. RS232 to USB Converter [caption id="attachment_45" align="alignnone" width="500" caption="Serial RS232 to USB"][/caption] This is...
  5. Keypad Using Parallel Port ** This Schematic need driver , Please Send Email...